String Silencers vs String Stop (2026)
These are not alternatives, they treat different noise. String silencers sit on the string and damp its own vibration after the shot. A string stop catches the string at the end of its travel and kills the whole system oscillation, which is where most of the sound and hand shock comes from on a modern compound. If you have neither, fit the string stop first. Silencers are cheap enough to add anyway.
At a glance
| LimbSaver String Silencers 4 Pack | LimbSaver String Decelerator Kit | |
|---|---|---|
| What it damps | String vibration | String travel and riser shock |
| Where it mounts | Woven into the string | Bolted to the riser |
| Speed cost | Small, adds string mass | Effectively none |
| Works on a recurve | Yes | No |
| Fitting | By hand, no press | Bolt on, needs alignment |
| Cost | Very low | Moderate |
Choose the LimbSaver String Silencers 4 Pack if…
You shoot a recurve or a longbow, where there is nothing to bolt a stop to and string silencers are the standard answer, or you want to shave a few more decibels off a compound that already has a stop. Woven rubber or fur silencers on the string cost almost nothing and take a couple of minutes to fit.
The trade is arrow speed, because everything added to the string is mass the limbs have to accelerate. On a recurve the noise reduction is worth it. On a compound, place them where the string is not moving fastest and use the minimum that quiets the bow.
Check LimbSaver String Silencers 4 Pack on Amazon
Choose the LimbSaver String Decelerator Kit if…
You shoot a modern compound and want the largest single reduction in shot noise and hand shock available for the money. A string stop intercepts the string just past brace height, ending the oscillation instead of letting the string ring the riser and limbs. The effect is obvious the first shot.
Alignment matters. The rubber head must contact the string squarely and at the correct depth, because a stop set too far forward slows the arrow and one set too far back does nothing. Follow the manufacturer setting, then paper tune again, because contact with the string changes how the bow behaves.
Check LimbSaver String Decelerator Kit on Amazon
Related
Comparison based on published manufacturer specifications and the general consensus of owner reports. We have not tested these products side by side. Confirm current specifications and prices before buying. As an Amazon Associate we earn from qualifying purchases, at no extra cost to you.
Frequently asked questions
Will these make my bow silent?
No. They reduce the ring and the shock, and they cut the sound that carries. The remaining noise is the limbs and the arrow leaving, and no accessory removes that. Reducing noise matters for close range hunting because it buys a fraction of a second before an animal reacts, but nothing makes a bow quiet enough to rely on.
Do string silencers slow the arrow down?
Slightly, yes. Mass on the string is the most expensive place to add weight in terms of speed, so a heavy set of silencers can cost a few feet per second. It is a small price for a much quieter recurve, and on a compound with a string stop you may not need many at all.
Where should string silencers be placed?
Roughly a third of the way in from each string end is the usual starting point, and moving them a little in either direction changes the note. Fit them, shoot, listen, and adjust. Keep them clear of the peep and away from anything they can contact at full draw.
Is a noisy bow a sign of a problem?
It can be. Excess noise often means an arrow that is too light for the bow, a loose accessory, a limb bolt that has backed out, or a cam that is out of time. Before adding damping parts, check that everything is tight and that your arrow meets the minimum grains per pound the bow maker states, because shooting under that voids warranties and can damage the bow.
How we choose: we compare published manufacturer specifications, verified owner reviews, and pro shop guidance. We do not test gear in person. Draw weight and arrow spine affect safety, so follow your bow manufacturer's specifications and have setup work checked by a qualified pro shop.
